Cables To Go SATA Converter Board
Save your old IDE drives with the new Cables To Go SATA Converter Board! This cable saves you from the large infrastructure cost from disposing your old IDE drives. You can just plug in the old IDE drivers to be compatible with the latest hard drive format using the SATA Converter Board. Just connect your IDE drives to the Serial ATA controller using the Serial ATA power cable and you are ready to boot in. This combination will yield results comparable to the original SATA disk and saves chunks of money in terms of infrastructure investment. Get the Cables To Go SATA Converter Board to plug in your IDE disk to SATA controller!
Have an opinion on this product that you would like to share? If, so please take a few moments to write your rating and review.Write your own review
works great, no issues. Cables to go builds well thought out stuff even though they are a bit more expensive. i set everthing on cable select and choose the path (d,e,f,etc)through plugging things into sata connectors. a bit bulky, but i don't care as i have plenty of room in a full tower case.
It works perfect!
Bought this to re-use an old IDE DVD RW drive to add to my HP SFF DC 5700. There is a catch though, I had to set it up cable select to make it work. Once I did that the PC bios recognized the drive right away.
It's working great so far! My old hard drive is back in service!
good product BUT
recieved it in good time. a little bulky and with comes sata cable but no power cable other than that works great and install a snap
Works great, but instructions are wrong
I bought several of these adapters because I had to convert hard drives and DVD drives to SATA on two unit upgrades. The instructions tell you to set each drive to Master...WRONG! Use the Cable Select setting and they work like magic. No problems after I stumbled on to that trick. Even their technical assistance didn't know.
11 Harbor Park Drive,
Port Washington, NY 11050.